Home Racker Plate

Plate width (X axis) in base units of 15 mm. One lock pin hole per unit along each edge. · Allowed: 1 – 50

Plate height (Y axis) in base units of 15 mm. · Allowed: 1 – 50

Plate thickness in mm. · Allowed: 2 – 5

Recess on the underside, 2.5 mm wider than the supports on each side and 2.5 mm deep, so connectors sitting on the supports (2 mm walls) fit under the plate. Only applied for thickness 3.5 mm and above and plates of at least 3 x 3 units.

Lock pin holes in the four corner cells too (a corner connector core has no hole underneath, but a plain support has).

1 mm chamfer on the top edges and 0.8 mm chamfer on the hole entries, like the other HomeRacker parts.

Extra plate material beyond the outline of the supports, on every side, in mm. 0 = plate flush with the outer faces of the supports. · Allowed: 0 – 5

Clearance added to the 4 mm lock pin holes. 0 = HomeRacker standard (holes match the pin, no tolerance). · Allowed: 0 – 0.4

Show ghost supports under the plate in the preview (F5 only, never exported).

Also show ghost corner connectors on the supports (drawn on edges of 4 units and more).