UMS Humidifier bottle holder

The two standard bottles, or any diameter you like

Used when bottle is custom · Allowed: 20 – 160

Clearance in the cradle. V1 uses none and lets print tolerance do it · Allowed: 0 – 2

Allowed: 45 – 60

Clearance between front and back part, on every mating face · Allowed: 0 – 0.6

Dimple for the back part's detent: this is what makes it click

Wall of the ring · Allowed: 1.2 – 6

Height of the bore, measured off the floor · Allowed: 20 – 200

Floor the bottle stands on · Allowed: 1.2 – 10

0 closes the ring. Width 0 = auto, which lands on V1's 26 at the 56 · Allowed: 0 – 120

Lowest point of the slot, above the bed · Allowed: 0 – 120

0 keeps the sides parallel all the way up · Allowed: 0 – 60

corners at the top rim · Allowed: 2 – 60

Lead-in chamfer at the top of the bore, so the bottle drops in · Allowed: 0 – 8

eroded by this much and put back, so it must stay under half the wall · Allowed: 0 – 2

Chamfer where the wall meets the floor inside the cradle · Allowed: 0 – 8

spilled into it, which is worth a decision rather than a default · Allowed: 0 – 60

Chamfer round both ends of the drain · Allowed: 0 – 4

which lands on V1's own 42 and 44 at the two standard bottles · Allowed: 0 – 160

Plate depth, from the socket mouth plane to the front face the ring sits on · Allowed: 5 – 40

Material above the seat · Allowed: 3 – 20

Plate carried above the top of the ring · Allowed: 0 – 20

Blend between ring and plate · Allowed: 0 – 20

Chamfer where the part meets the bed · Allowed: 0 – 2

whatever the infill. Below about 0.12 a slicer closes it up again

Allowed: 0.05 – 0.5

Allowed: 1 – 10

Allowed: 1 – 6