Ultrasound Probe Holder

Inside diameter at the bottom. The narrowest probe rests here · Allowed: 12 – 80

Inside diameter at the top. The widest probe rests here · Allowed: 20 – 120

Overall height. Never more than 80 · Allowed: 50 – 80

Width of the groove down the front for the cable · Allowed: 10 – 20

groove widens upward, its face looks up, and nothing limits it · Allowed: 0 – 70

Radius of the top arc: larger opens more gently, over a longer stretch · Allowed: 20 – 80

which is an overhang when the part prints standing · Allowed: 0 – 20

Radius of the bottom arc · Allowed: 3 – 40

Chamfer on the rim, top and bottom, inside and out · Allowed: 0.4 – 3

Round on the four edges of the cable groove · Allowed: 0 – 2.5

Wall thickness, measured square to the funnel's surface. Never under 3 · Allowed: 3 – 6

of all. 0 leaves the funnel standing on its own wall · Allowed: 0 – 20

wide, the foot is a solid pedestal holding the cone, not just a flange · Allowed: 3 – 60

width. 0 leaves the web alone · Allowed: 0 – 6

covers the first layers anyway. It was also eating the footprint · Allowed: 0 – 1

Allowed: 45 – 60

Clearance between front and back part, on every mating face · Allowed: 0 – 0.6

Dimple for the back part's detent: this is what makes it click

Back plate width · Allowed: 31 – 80

Back plate depth, from the socket mouth plane forward · Allowed: 6 – 20

Material above the seat · Allowed: 2 – 15

Chamfer on the plate's edges · Allowed: 0 – 2

closes it up again

Allowed: 0.05 – 0.5

Allowed: 1 – 10

Allowed: 1 – 6